Stoneguard, gray | LIQUI MOLY

Clean the surfaces to be treated thoroughly in advance and remove rust. The surfaces must be dry and free of wax, dirt and grease and largely free of dust.

Shake well before use! The adhesion is improved if the surface to be treated is roughened first. Can be applied with the UBS Spray Gun (part no. 6219) or the Compressed Air Can Gun (part no. 6220) at an operating pressure of 2 – 4 bar depending on the desired spray pattern. Can be painted over after approx. 60 – 90 min. (depending on film thickness, temperature and humidity). Most of the usual water and solvent-based 2C paints and base coats can be used here. When using a 2C paint, we recommend using a coat of plastic primer first and painting over this coat after it is completely dry, as recommended by most paint manufacturers.

Recommended application temperature: 15 – 25 °C

We recommend applying thin coats. Depending on the desired layer thickness, intermediate drying should be carried out after each layer. If the stoneguard is subsequently painted over, the coats will become increasingly hard. In other words, the treated surface should be treated accordingly with adhesive primer for plastics in the same way a plastic surface would be.

Do not leave containers standing open as a skin will form on the surface of the material.

Do not spray onto moving parts and hot components such as mechanical joints, the engine, transmission, cardan shaft, exhaust pipe, catalytic converter and brake systems!

A clogged spray gun can cause the can to burst!

Note the operating instructions for the spray gun.

After use, clean the spray gun using the cleaner intended for the purpose.